Products

HI GEAR Cooling system rinsing for commercial vehicles 444ml.  

This Hi-Gear HG9017 connection is intended to flush the vehicle's cooling system.  

The concentrated formula safely cleans the cooling system of scale, grease-like deposits, rust, antifreeze (antifreeze) decomposition products.  

Prevents local cylinder block overheating caused by scale clogging of the cooling jacket and protects the engine from cramping.  

Flushing the Cooling System Hi-Gear HG9017 restores coolant circulation, relieves clogged sludge radiator pipes and increases. cooling efficiency by 50 - 70%; reduces the possibility of engine overheating in congestion. Remove the radiator or expansion tank cap for a cold, uncooled engine.  

Open the tap of the internal heater, start the engine and let it idle for 2-3 minutes.  

Do not let it heat above +60 degrees Celsius.  

Stop the engine and, as a precaution, drain the coolant completely from the radiator and cylinder block.  

Mix the contents of the package with 4-5 liters of clean water (if there is a precipitate of crystalline inclusions in the preparation, stir until it dissolves) and pour the solution into a radiator or expansion tank.  

Fill the cooling system with clean water to operating level, close the lid.  

Fully open the internal heater valve, start and warm the engine at idle and medium speed for 7 minutes.  

Stop the engine, wait 2-3 minutes. as a precaution, drain the flea from the radiator and cylinder block.  

Repeat rinsing the cooling system with clean water to remove any debris.  

Do not leave water in the cooling system for a long time at negative air temperatures.  

Fill the cooling system with new antifreeze (antifreeze).  

This package is designed for cooling systems from 10 to 22 liters.